Listed below are just a few of the parts that we have produced. These images can be "super-sized" by clicking on the thumbnail.

High Pressure Turbine Accelerator made of Rene 41 and is approximately 7” in diameter. This part required very intricate brazing as well as close tolerance machining.
	This is an Exhaust Case made of Inconel 718 approximately 40” in diameter and 40” tall, and weighs 2400 pounds. This part required Electron Beam Welding.
Blankoff Plate made of stainless steel, with a diameter of roughly 19”.
	Inner Liner Assembly made of stainless steel. This assembly is composed of 5 sub-assemblies, all of which required very close tolerance machining and many special processes.
This is an Aluminum Flanged Combustion Case approximately 33” in diameter and 27” tall.
	This is an inlet Scoop made of Aluminum that is approximately 7.5” wide and 17” long. The part required a substantial amount of 3 dimensional millwork.
This is a Stage 1 to Stage 2 Spacer Arm made from one Titanium Forging. The part is roughly 16" in diameter, and 5 " tall. There are knife edge seals on the Outside Diameter, that have extremely tight tolerances.
	This is a Split Case approximately 35” tall and 30” in diameter. This part was machined out of a one-peice 4000 lb stainless steel forging, and required a vast amount of intricate CNC machining to extremely tight tolerances.
Inner Bellmouth made of Inconel 718. The part required Electron Beam Welding, and CNC machining. It measures 24" in diameter and 21" tall.
	This is an Aft Bullet Nose made of one-peice Aluminum forging. It measures 28" in diameter and 16" tall.
Inner Support made of Inconel 718. The part is approximately 18” in diameter and 16” long. This piece required Electron Beam Welding and close tolerance machining.
	This is an Aluminum Bellmouth Flange. It was formed from a one-piece forging. The part required close tolerance machining, and hard coat anodize. It measures 37" in diameter and 13" tall.
These are flex rings made of Waspaloy. There is a substantial amount of CNC millwork on this piece. Special processes include Shot Peen. They measure 19" in diameter and 4" tall.
	Here is an Inner Support Nozzle. Although a relatively small part, there is an enormous amount of detail, and extremely close tolerance machining is required on this piece. It measures 7" in diameter and 1" tall.
This is an Aft Seal Support made of Inconel 718. The part required EB Weld. This is a thin-walled part that required a substantial amount of tight tolerance CNC mill work.